Identified, on a case-by-case basis, from scientific evidence as causing probable serious effects to human health or the environment of an equivalent level of concern as those above (e.g. Persistent, Bioaccumulative and Toxic (PBT) or very Persistent and very Bioaccumulative (vPvB) according to the criteria in Annex XIII of the REACH Regulation, orģ. Carcinogenic, Mutagenic or toxic to Reproduction (CMR), meeting the criteria for classification in category 1 or 2 in accordance with Directive 67/548/EEC or in category 1a or 1b in accordance with EC No 1272/2008This directive was recently replaced by the new EU regulation (EC) No 1272/2008.Ģ. SVHC are defined in Article 57 of Regulation (EC) No 1907/2006 (“the REACH Regulation”) and include substances which are:ġ. It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent a good adhesion.SVHC is a substance (identified by the European Chemicals Agency) that may have serious and often irreversible effects on human health and the environment. Immediately continue to coat the next section (note: fresh paint can be applied over the loose chips that lay outside the previously painted area). This will not affect the performance of the coating).
Sprinkle the decorative paint chips onto the wet film (note: this step may be skipped if chips are not desired. Maintain a wet edge to prevent lap marks and gloss differences. Apply in sections of 1,5 x 1,5 m so that Epoxyshield Decorative Chips can easily be scattered on the freshly coated surface.
#RUST OLEUM EPOXYSHIELD FULL#
Application and ThinningĪfter the full 60 minutes use a paint roller (20 cm) to apply an even coat to the surface. Do not mix Paint Chips with Epoxyshield Garage floor coating. This time decreases at higher temperatures. The product must be used within 1 to 2 hours of initial mixing. Do not leave container in direct sunlight. Allow mixed product to stand (see table) before rolling the coating on to the surface. Pour the contents of A into B and stir thoroughly for at least 3 minutes.
Remove all water and allow to dry completely. Rinse thoroughly with fresh water afterwards. Remove oil and grease using a scrubbing brush and ND14 cleaner degreaser. If the floor is previously painted, remove any loose paint by sanding and scraping. They give a decorative finish and will also mask dirt. The chips adhere permanently on the floor when they are sprinkled in the wet coating. The Epoxyshield Decorative Chips are specially designed for use in combination with Epoxyshield Garage Floor Coating.
#RUST OLEUM EPOXYSHIELD FREE#
Detailed instructions and a free Instructional DVD.Resists oil, petrol, anti freeze, salt and hot tyre pick up.It can also be applied on sound previously painted floors. Epoxyshield Garage Floor Coating can be applied on concrete floors, which are completely clean and dry.
0 kommentar(er)
